e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
6 - 44
6. Printer-specific Adjustments (GA-1211)
6.8.2 To Change Default Setting of Sharpness Level
Procedures
* The service technician must perform all adjustments.
* All the adjustments will be effective only when images are printed with a PS3 printer driver in the Full color
mode.
(1) Enter the adjustment mode [05]. Change the value for the code [8119] to adjust the default value of the sharpness
level (sharpness intensity at the center value).
[05] code Subcode Recommended value
Acceptable
value range
Default
05-8119 1/2
Set a value larger than 128 to make the
image sharper.
Set a value smaller than 128 to make
the image softer.
0 to 255 128
* The subcode varies according to the area where the sharpness is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
Areas where the sharpness
is adjusted
1 Line art (graphics)
2 Photo
Precautions after the completion of the adjustment
Nothing in particular.
To Next Page
Loading...
