e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 3
2. Copier-specific Adjustments
After increasing the sharpness intensity, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(4) Press the [BASIC] button on the Control Panel. Select "TEXT" from among the original mode options.
* To have "TEXT" selected from among the original mode options by default, refer to procedure (1) in 2.8
To Eliminate Moiré.
After selecting the Text mode, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(5) Enter adjustment mode [05]. Decrease the values for codes [7097], [7098], [7252], [7102] and [7103] to
make the text darker (improving faint text or thin lines).
Original mode [05] code
Recommended
value
Acceptable
value range
Default
Text / Photo 05-7097
Text 05-7098
User custom 05-7252
Auto color (when
judged as black)
Text/Photo
05-7102
Auto color (when
judged as black)
Text
05-7103
Set a value smaller
than 2.
0 to 4 2
* Set the value in increments of approximately 1, while checking the copy image until the optimum value is
obtained.
After increasing the copy density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
To Next Page
Loading...
