e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 21
2. Copier-specific Adjustments
To make another adjustment of the background for Full color after the above adjustment
* Adjust the density level while checking the color balance since it may differ from that of the original after
the adjustment.
Color mode Original mode [05] code
Recommended
value
Acceptable
value range
Defa
ult
Text/Photo 05-7744
Text 05-7745
Full color / Auto color
(when judged as color)
<Automatic adjustment>
Printed Image 05-7746
Photo 05-7747
Map 05-7748
"Full color
<Automatic
adjustment>"
User custom 05-7762
Text/Photo 05-7749
Text 05-7750
Full color / Auto color
(when judged as color)
<Manual adjustment>
Printed Image 05-7751
Photo 05-7752
Map 05-7753
Full color
<Manual adjustment>
User custom 05-7763
Set 128 or larger. 0 to 255 128
* The value for automatic adjustment will be applied only if the automatic copy density mode is selected.
On the other hand, the value for manual adjustment will be applied only if the manual copy density mode
is selected.
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
<Note> "Making the highlighted area more visible (or increasing the background density)" and
"eliminating the background color (or decreasing the background density)" are mutually
contradictory. If the background color is darkened to make the highlighted area more visible,
the hue of the background may change.
After adjusting the background density, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(3) Press the [BASIC] button on the Control Panel. Press the [ ] button to increase the copy density.
After increasing the copy density, copy and check the copy image quality.
With the copy density set to the maximum, if further image quality adjustments are still necessary, the
service technician must use the next procedure.
To Next Page
Loading...
