e-STUDIO2040C/2540C/3040C/3540C/4540C © 2011 TOSHIBA TEC CORPORATION All rights reserved
2 - 44
2. Copier-specific Adjustments
(1) Press the [BASIC] button on the Control Panel and select the original mode option, as follows:
• To copy in the Full color or the Auto color mode: Select the Printed image mode option.
• To copy in the Black mode: Select the Photo mode option.
* When copying a photo image in the Full color mode, select the Photo mode option from among the
original mode options.
* To have the above original mode options selected by default, refer to procedure (1) in 2.8 To Eliminate
Moiré.
After changing the default original mode option, copy and check the copy image quality.
If further image quality adjustments are still necessary, use the next procedure.
(2) Press the [IMAGE] button on the Control Panel. Press the [SHARPNESS] button.
Press the [SOFT] button to soften the copy image.
After softening the copy image, copy and check the copy image quality.
If further image quality adjustment is necessary, go to the next step.
(3) Enter adjustment mode [05]. Change the values for codes [7056] to [7058], [7249], [7795] to [7800] and
[7795] to [7809] to adjust the default value for the sharpness intensity.
* Decreasing the sharpness intensity will minimize the edges of the image.
Color mode Original mode [05] code
Recommended
value
Accepta
ble value
range
Default
Text / Photo 05-7056
Text 05-7057
Photo 05-7058
User custom 05-7249
Black
Image smoothing 05-7809
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text / Photo 05-7796
Text 05-7797
Printed image 05-7798
Photo 05-7799
Map 05-7800
Full color
User custom 05-7795
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
Text / Photo 05-7806
Text 05-7807
Auto color
(when judged
as black)
Photo 05-7808
Set a value smaller
than 128.
(28 to 127)
0 to 255 128
To Next Page
Loading...
