Toshiba E-STUDIO 232 - Punching Holes

5 Printing from Windows
248 Printing with Extended Print Functionality
Stapling the paper
1
Display the Setup tab and select how to staple at the “Staple” drop
down box.
Upper Left — Select this to staple the printed document in the upper left.
Center Top — Select this to staple the printed document double along the top edge.
Upper Right — Select this to staple the printed document in the upper right.
Middle Left — Select this to staple the printed document double along the left side.
Center Double — Select this to fold and staple the printed document double in the
center.
y The selectable options vary depending on the paper size.
y “Center Double” can be selected only when the Saddle Stitch Finisher is installed and
configured on the Configuration tab.
2
Set other print options you require and click [OK].
3
Click [OK] or [Print] to send a print job.
y The output is stapled for each copy.
Punching holes
1
Display the Setup tab and select how to punch holes at the “Hole
Punch” drop down box.
Center Top — Select this to create holes along the top edge.
Middle Left — Select this to create holes along the left side.
2
Set other print options you require and click [OK].
3
Click [OK] or [Print] to send a print job.
y The output is hole punched.