.
14 (GB) Safety Information
y (e-STUDIO2309A/2809A) The Paper Feed Pedestal has 6 adjusters (antiskid devices)
underneath. After the equipment has been moved and installed, be sure to turn and lower
them to fix it.
Then fix the fall-prevention stoppers.
Do not install the equipment by yourself or try to move it once it has been installed. This could
result in an injury or damage to the device. Contact your service representative if the equipment
needs to be installed or moved.
Other points
y The socket outlet shall be installed near the equipment and shall be easily accessible.
y If there is insufficient space around the equipment, the poor ventilation will result in
malfunction, also some operations such as bypass feeding and releasing paper misfeeds may
become difficult. To ensure adequate space, follow the table below as a guide.
y Be sure to fix the power cable securely so that no one trips over it.
y Adverse environmental conditions may affect the safe operation and performance of the
Multifunctional Digital Systems, and the Multifunctional Digital Systems could break down.
- Avoid locations near windows or with exposure to direct sunlight.
- Avoid locations with drastic temperature fluctuations.
- Avoid too much dust.
- Avoid locations that suffer from vibration.
y Make sure that the air is able to flow freely and that there is sufficient ventilation.
Without adequate ventilation, the unpleasant odor released by ozone will begin to dominate
the atmosphere.
Adequate space
Rear Left Right
20 cm (7.9") 30 cm (11.8") 80 cm (31.5")
To Next Page
Loading...
