84
3.SETTING ITEMS (USER)
1.SETTING GENERAL FUNCTIONS (Cont.)
3
7
Place the printed chart face down on the glass with its bottom toward
you and its top left aligned against the original scale on the left side,
in order that the black line be placed at the left side.
8
Press the [START] button.
• When the calibration setting is completed, the GENERAL menu will be displayed.
If the chart is not properly placed, the message “Set chart correctly” is displayed on the touch panel. In this case,
go back to step 7 and place the chart again.
To Next Page
Loading...
