10
June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 DRIVE SYSTEM
10 - 5
10.4 Disassembly and Replacement
[A] Main motor
[B] Main motor drive unit
(1) Take off the SYS board case
(! P.2-46 "[D] SYS board case").
(2) Disconnect 1 connector. Remove 2 screws,
release 2 locking support, and then take off
the main motor.
Fig.10-3
(1) Take off the process unit
(! P.11-8 "[A] Process unit").
(2) Take off the SYS board case
(! P.2-46 "[D] SYS board case").
(3) Take off the connecting port cover
(! P.2-37 "[O] Connecting port cover").
(4) Remove 1 screw and take off the flywheels.
Fig.10-4
Screw
Screw
Connector Main motor
Flywheel
To Next Page
Loading...
