206 Printing Guide — Printing from Windows
2. Display the [Configuration] tab and set the following options.
Pedestal — This sets whether or not optional drawers or large capacity feeder is
installed.
Finisher — This sets whether or not optional finisher is installed.
Hole Punch — This sets whether or not optional hole punch unit is installed.
Automatic Duplexer — This sets whether or not optional automatic duplexer is
installed. (e-STUDIO280 Series Only)
Upper Drawer/Paper Type — Select the paper size and paper type of paper that
is loaded in the Upper Drawer.
Lower Drawer/Paper Type — Select the paper size and paper type of paper that
is loaded in the Lower Drawer.
Pedestal Upper/Paper Type — Select the paper size and paper type of paper
that is loaded in the Pedestal 1 when it is installed.
Pedestal Lower/Paper Type — Select the paper size and paper type of paper
that is loaded in the Pedestal 2 when it is installed.
Large Capacity/Paper Type — Select the paper size and paper type of paper
that is loaded in the Large Capacity Feeder when it is installed.
Bypass Feeder — Select the paper type of paper that is loaded in the Stack
Feed Bypass.
Memory — Select the size of memory.
SUPPLEMENT:
• For more information about each item, see descriptions about the Configuration
Tab.
P.246 "Configuration Tab"
3. Click [Apply] and [OK] to save settings.
— Configuring the Options Automatically
The following describes an instruction on Windows 2000. The procedure is the same when
other versions of Windows are used.
To Next Page
Loading...
