Toshiba e-Studio 350 - Department Code; Distinguish Thin Lines; Smoothing

Printing Guide — Printing from UNIX 315
If this option is not specified, the printer’s default value will be used.
— Department Code
The department access code can be set using the following option.
SUPPLEMENT:
• How the equipment performs printing for an invalid department code print job, which
no department code or invalid department code is specified, varies depending on
the Department Code Enforcement setting that can be set from TopAccess Adminis-
trator mode. When the Department Code Enforcement is enabled, the invalid
department code print job will be stored in the invalid department code print job list
without printing. When the Department Code Enforcement is disabled, the invalid
department code print job will be printed.
— Smoothing
The smoothing mode can be set using the following option.
Example: The command to set the smoothing mode is “lp –o smoothing=on filename”.
— Distinguish Thin Lines
The thin line limit mode can be set using the following option.
Example: The command to set the thin line limit mode is “lp –o thinlinelimit=on filename”.
private=din Process as a private print job. The din is 5-digit Document ID
number.
Option Value Alternate
Value
Description
dept=code Set the department access code. The code is a 5-digit numeric
value.
Option Value Alternate
Value
Description
smoothing=
on
ON Set the smoothing mode.
smoothing=
off
OFF Cancel the smoothing mode.
Option Value Alternate
Value
Description
thinlinelimit=
on
ON Set the thin line limit mode.
thinlinelimit=
off
OFF Cancel the thin line limit mode.
Option Value Alternate
Value
Description