5 Printing from Windows
232 Setting Up Print Options
y The selectable options vary depending on the paper size.
y “Center Double” can be selected only when the Saddle Stitch Finisher is installed.
y 2-Sided printing cannot be set when the following paper size in selected at the “Print
Paper Size” drop down menu in the Basic Tab.
-A5
-A6
- Statement
-A4 Tab
- Letter Tab
5) Hole Punch
This sets whether a print job is printed with hole punches.
- Center Top — Select this to create holes along the top edge and print.
- Middle Left — Select this to create holes along the left side and print.
Hole punching can be selected only when a hole punch unit is installed.
6) Use Custom Margin
Check this to set the margin on the printed pages. When this is checked, click [Detail...] to
set the margins in the Custom Margin dialog box.
The margin range is between 5 mm and 100 mm. Less than 5 mm cannot be set for the
range.
y Enable this function to add the margins if the application does not support the margin
function. When the application has the margin function, use the application’s function
rather than this option.
y This cannot specify the binding margin for Booklet printing.
To Next Page
Loading...
