Toshiba e-STUDIO 452 - Toner Save; Booklet Modes

Printing from an Application 329
Do not Print Blank Pages
The Blank page mode can be selected using the following option.
Toner Save
The toner save mode can be set using the following option.
Example: The command to set the toner save mode is “lp -o tonersave=on filename”.
Booklet Modes
The booklet mode can be selected using the following options.
The booklet printing cannot be performed when no Automatic Duplexing Unit is installed.
Option Value
Alternate
Value
Description
blankpage=0 Set the blank page mode (disable Do not Print Blank
Pages).
blankpage=1 Cancel the blank page mode (enable Do not Print Blank
Pages).
Option Value
Alternate
Value
Description
tonersave=on ON Set the toner save mode.
tonersave=off OFF Cancel the toner save mode.
Option Value
Alternate
Value
Description
booklet=letter lt
LT
Select letter size paper for booklet printing mode.
booklet=A4 a4 Select A4 size paper for booklet printing mode.
booklet=legal lg
LG
Select legal size paper for booklet printing mode.
booklet=
statement
st
ST
Select statement size paper for booklet printing mode.
booklet=ledger ld
LD
Select ledger size paper for booklet printing mode.
booklet=folio folio-japan Select folio size paper for booklet printing mode.
booklet=A3 a3 Select A3 size paper for booklet printing mode.
booklet=A5 a5 Select A5 size paper for booklet printing mode.
booklet=B4 b4
B4-JIS
b4-jis
Select JIS B4 size paper for booklet printing mode.