Toshiba e-studio 4555c - Bypass Copying on Non-Standard Size Paper

2 HOW TO MAKE COPIES
58 Bypass Copying
 Bypass copying on non-standard size paper
1
Place the original on the original glass.
y The height of the paper must not exceed the indicator on the side guides.
y When you use more than one sheet of paper, fan the sheets well before placing them on the
bypass tray. Be careful not to cut your fingers when fanning.
y Do not push paper into the entrance of the bypass feeder. This could cause a paper misfeed.
You can use non-standard size paper within the sizes shown on the
right.
2
Move the paper holding lever toward the outside.
Place paper with its copy side down on the bypass
tray.
3
Align the side guides to the paper length. Move the
paper holding lever toward the equipment.
When paper is placed, the menu for bypass copying appears.
100
-
297 mm
(
3.9"
-
11.7"
)
148
-
432 mm
(
5.8"
-
17"
)
2
1