Toshiba e-Studio 907 - COPY OUTPUT CONFIGURATION; Basic Output Operations; Output Tray and Sorting Options; Stapling Options

16
Congure the output settings for copies using Sort, Group, Offset, Staple, Punch, or Fold.
Basic operations
1
Select [Output]
2
Copy output settings
3
Check the preview image
4
Start
1 Specify the output tray
2 Select the output and paper output type
3 Specify the details of output mode
COPY OUTPUT
Output tray settings
Specify the destination to output copies.
The output tray currently selected is indicated by an arrow.
(When a nisher (50-sheet stapling) or saddle nisher (50-sheet
stapling) is installed)
The [Top Tray] key can be selected.
(When a nisher (100-sheet stapling) or saddle nisher
(100-sheet stapling) is installed)
The [Middle Tray] key can be selected.
When a large capacity stacker is installed
You can select the [Top Tray] key or [Stacker Tray] key.
Offset
Tray
Outputs to the offset tray
Offset
Offset function
Select this function when you wish to output copies while shifting
them set by set.
Selecting the staple function clears the Offset checkmark
automatically.
Separator
Page
Separator Function
You can insert separator pages for every specied number of
copies or before or after each job.
Sort/Group function
This function sets the sorting method when copying a scanned
document.
Sort
Sorts the scanned document on a set basis,
and outputs them
Group
Groups the scanned document on a page
basis, and outputs them.
Sort staple
This function staples the output copies and deliver them to the tray.
1 staple in back
1 staple in front
2 Staples
Saddle
Stitch
Copies can be folded at the center, stapled,
and output.
This function is only available when a saddle
nisher is installed.
Slant
Staple
Enables slant stapling.
This function is available when [1 Staple at
Back] is selected while a nisher (50-sheet
stapling) or saddle nisher (50-sheet stapling)
is installed.
Output tray settings