41
2
4
While pushing the size selection lever in
the direction of the arrow, set the side
guide to the desired paper size (indicated
on the bottom inner surface of the
drawer).
- Adjust the side guides with both hands.
5
Push the arrow part (left side) to lock the
size selection lever.
6
Place paper in the drawer(s).
- Place paper face up.
- Maximum number of sheets that can be set. "Acceptable Copy
Paper Types and Sizes" Page 38
- Fan the paper well before placing it in the drawer.
- Do not add paper above the line indicated on the guide.
- Do not use creased, folded, wrinkled or damp sheets of paper.
Make sure that a gap of approx. 0.02” (less than 0.04” in total) is left
between the paper and the side guide. If there is no gap, this could
cause paper misfeeding.
7
Push the drawer straight into the copier
until it comes to a stop.
- Be sure to push the drawer fully in.
Be careful not to let your fingers be caught when closing the drawer.
This could injure you.
0.5mm
(
0.02’’
)
To Next Page
Loading...
