Toshiba E-STUDIO E-Studio 3511 - Staple Sorting; Setting Staple Sort Mode

82
3.SETTING OF BASIC COPY MODES
4.SELECTING FINISHING MODES (Cont.)
3
Staple Sorting
When the finisher (optional) is installed, you can perform automatic stapling for every set. 3 staple positions
can be selected when installing the saddle-stitch finisher (MJ-1024) or multi-staple finisher (MJ-1023).
* The paper weight should be in the range of 17-28 lb. for the saddle-stitch finisher (MJ-1024) or multi-
staple finisher (MJ-1023), and 17-20 lb. Bond for the single-staple finisher (MJ-1022). Special paper such
as OHP films or labels is excluded.
* Stapling will not work when copied paper of different widths are mixed.
- Example of selecting the [FRONT STAPLE-1] button
Setting Staple Sort Mode
1
Place paper in the drawer(s).
- "1.SETTING COPY PAPER"  Page 38
- When using this mode in bypass copying ("Bypass Copying" 
Page 60), be sure to specify the paper size.
2
Place the original(s).
- "2.SETTING ORIGINALS"  Page 47
3
Press the Finisher button on the basic
menu as shown in the illustration on the
right (highlighted).
AB
AB
AB