June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 85
2
Notes:
• The digit after the hyphen in “Code” of the following table is a sub code.
• e-STUDIO200L/230/280: In “RAM”, the NVRAM of the board in which the data of each code
is stored is indicated. “M” stands for the LGC board, “SYS” and
“UTY” stands for the SYS board and “NIC” stands for the NIC
board.
Setting mode (08) <e-STUDIO200L/230/280>
Code
Classifi-
cation
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Proce-
dure
200 General Date and time setting ALL -
<13 dig-
its>
- Year/month/date/day/
hour/minute/second
Example:
03 07 0 13 13 27 48
“Day” - “0” is for
“Sunday”. Pro-
ceeds Monday
through Saturday
from “1” to “6”.
5
201 General Destination selection ALL EUR: 0
UC: 1
JPN: 2
<0-2>
M 0: EUR
1: UC
2: JPN
1
202 User
interface
Counter installed externally ALL 0
<0-3>
M 0: No external counter
1: Coin controller
2: Copy key card
3: Key copy counter
1
203 General Line adjustment mode ALL 0
<0-1>
M 0: For factory shipment
1: For line
* Field: “0” must be
selected
1
204 User
interface
Auto-clear timer setting ALL 3
<0-10>
SYS Timer to return the
equipment to the
default settings when
the [START] button is
not pressed after the
function and the mode
are set
0: Not cleared
1 to 10: Set number x
15 sec.
1
205 User
interface
Auto power save mode
timer setting
ALL EUR: 11
UC: 11
JPN: 6
Others:
11
<0, 6-15>
SYS Timer to automatically
switch to the Auto
power save mode when
the equipment has not
been used
0: Invalid 6: 3min.
7: 4min. 8: 5min.
9: 7min.
10: 10min.
11: 15min.
12: 20min.
13: 30min.
14: 45min.
15: 60min.
1
05/12
To Next Page
Loading...
