Toshiba e-STUDIO200L - 7 Power Supply Unit

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 POWER SUPPLY UNIT
7 - 1
7
7. POWER SUPPLY UNIT
7.1 Output Channel
The followings are five output channels which are not linked with the door switch.
1) +3.3V
+3.3VA : CN705 Pins 13, 14, 15 and 16
Output to the SYS board
+3.3VB : CN705 Pins 19 and 20
Output to the SYS board
+3.3VB : CN706 Pin 30
Output to the LGC board
+3.3VB : CN708 Pins 9 and 10
Output to the SLG board
2) +5.1V
+5.1VA : CN705 Pins 24 and 26
Output to the SYS board
+5.1VB : CN705 Pin 25
Output to the SYS board
+5.1VB : CN706 Pin 26
Output to the FUS board
+5.1VB : CN706 Pins 27 and 28
Output to the LGC board, PFP/ LCF (via LGC board),
Bridge unit / Job separator / Offset tray (via LGC board)
+5.1VB : CN707 Pin 4
Output to the finisher
+5.1VB : CN708 Pins 3 and 4
Output to the SLG board
+5.1VB : CN708 Pins 5 and 6
Output to the RADF
3) +12V
+12VA : CN705 Pin 7
Output to the SYS board
+12VB : CN705 Pin 5
Output to the SYS board
+12VB : CN706 Pin 22
Output to the LGC board
+12VB : CN708 Pin 13
Output to the SLG board
4) -12V
-12VA : CN705 Pin 9
Output to the SYS board
-12VB : CN705 Pin 3
Output to the SYS board
5) +24V
+24VB : Not used