Toshiba e-STUDIO200L - 2 Error Code and Self-Diagnostic Mode

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 1
2
2. ERROR CODE AND SELF-DIAGNOSTIC MODE
2.1 Error Code List
2.1.1 Jam
One of the following error codes is displayed at the upper right of the screen while pressing the
[CLEAR] button and the digital key [8] simultaneously when the “CLEAR PAPER” or “CALL SER-
VICE” symbol is blinking.
Error code Classification Contents Troubleshooting
E010 Paper exit jam Jam not reaching the exit sensor: The paper which
has passed through the fuser unit does not reach
the exit sensor.
P. 5-1
E020 Stop jam at the exit sensor: The trailing edge of the
paper does not pass the exit sensor after its leading
edge has reached this sensor.
P. 5-1
E030 Other paper jam Power-ON jam: The paper is remaining on the
paper transport path when power is turned ON.
P. 5-2
E090 HDD abnormality causes jam: Image data to be
printed cannot be prepared.
P. 5-3
E110 Paper misfeeding ADU misfeeding (Paper not reaching the 1st trans-
port sensor): The paper which has passed through
ADU does not reach the 1st transport sensor during
duplex printing.
P. 5-15
E120 Bypass misfeeding (Paper not reaching the 1st
transport sensor): The paper fed from the bypass
tray does not reach the 1st transport sensor.
P. 5-16
E130 Upper drawer misfeeding (Paper not reaching the
1st transport sensor): The paper fed from the upper
drawer does not reach the 1st transport sensor.
P. 5-17
E140 Lower drawer misfeeding (Paper not reaching the
2nd transport sensor): The paper fed from the lower
drawer does not reach the 2nd transport sensor.
P. 5-18
E150 PFP upper drawer misfeeding (Paper not reaching
the PFP upper drawer feed sensor): The paper fed
from the PFP upper drawer does not reach the PFP
upper drawer feed sensor.
P. 5-19
E160 PFP lower drawer misfeeding (Paper not reaching
the PFP lower drawer feed sensor): The paper fed
from the PFP lower drawer does not reach the PFP
lower drawer feed sensor.
P. 5-20
E190 LCF misfeeding (Paper not reaching the LCF feed
sensor): The paper fed from the LCF does not
reach the LCF feed sensor.
P. 5-21