Toshiba e-STUDIO200L - Adjustment of Skew

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 59
3
3.10.3 Adjustment of skew
When an image skew occurs, adjust it according to the following steps, Step 1 Step 2 Step 3.
Note: Note:
Perform this adjustment after confirming that the equipment has been adjusted properly.
Prior to this adjustment, of RADF position and height are needed to be adjusted.
(1) Step 1
Case A:
Adjust the aligning adjustment position to the rear side “-” of the original (! P.3-62 "3.10.5
Adjustment of aligning").
Case B:
Adjust the aligning adjustment position to the rear side “+” of the original (! P.3-62 "3.10.5
Adjustment of aligning").
Fig.3-65
A B
Paper
Original
White arrow: feeding direction