June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 19
3
[G] Right margin
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. # (Adjustment Mode)
(2) Open platen cover or RADF.
(3) Press [FAX] to make a copy at the mode of A3/LD, 100%, Text/Photo and standard drawer of the
equipment (Refer to *).
*Perform 08-477 and check the value.
If the value is 0, use the lower drawer.
If the value is 1, use the upper drawer.
(4) Measure the blank area F at the right side of the copied image.
(5) Check if the blank area F is within the range of 2±1.0 mm.
(6) If not, use the following procedure to change values and repeat the steps (3) to (5) above.
(Adjustment Mode) # (Key in the code [432]) # [START]
# (Key in a value (acceptable values: 0 to 255))
# Press the [ENTER] or the [INTERRUPT] button (stored in memory).
# (“100% A” is displayed.)
*The larger the adjustment value is, the wider the blank area at the right side becomes (approx.
0.04 mm/step).
Fig.3-17
F
Feeding direction
04/09
To Next Page
Loading...
