June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 45
5
[ 4 ] Paper jam in saddle stitcher section
[EAB0] Saddle paper transport stop jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
#
YES Remove the paper.
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
#
YES Connect the connector securely. Replace the harness.
NO
Is the folding position sensor working properly?
#
NO Replace the sensor.
YES
Replace the finisher controller PC board.
[EAC0] Saddle transport delay jam
MJ-1025
Is there any paper remaining on the paper transport path in the saddle stitcher section in the
finisher?
#
YES Remove the paper.
NO
Is the connector CN16 (folding position sensor) on the finisher controller PC board discon-
nected?
Is the harness connecting the finisher controller PC board and folding position sensor open-
circuited?
#
YES Connect the connector securely. Replace the harness.
NO
Is the folding position sensor working properly?
#
NO Replace the sensor.
YES
Replace the finisher controller PC board.
To Next Page
Loading...
