June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6 - 3
6
Important:
• The download jig (PWA-DWNLD-350-JIG) has two types having different ROM capacity.
ROM capacity for each jig is as follows.
* “PWA-DWNLD-350-JIG2 (48 MB)” is substitutable for “PWA-DWNLD-350-JIG1 (16 MB)”
• The download jig (PWA-DWNLD-350-JIG) is different type jig. The Flash ROM is installed on
the board directly. Therefore, ROM writer adapter (PWA-DL-ADP-350) is required to write the
data to these Flash ROMs. Refer to the following to write the data.
! P.6-20 "6.1.3 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
Fig.6-3 Jig board: K-PWA-DLM-320
Important:
Pay attention to the direction of the ROM.
Fig.6-1 Jig board: PWA-DWNLD-350-JIG2 (48 MB) Fig.6-2 Jig board: PWA-DWNLD-350-JIG1 (16 MB)
Download jig ROM capacity Application
PWA-DWNLD-350-JIG2 (48 MB) 8 MB x 6 Updating the master data
PWA-DWNLD-350-JIG1 (16 MB) 8 MB x 2 Updating the system ROM, engine ROM,
scanner ROM, NIC ROM
ROM4
ROM5
ROM6
ROM1
ROM2
ROM3
Connector
(
for SYS board
connection
)
Connector
(
for ROM writer
adapter connection
)
ROM1
ROM2
Connector
(
for SYS board
connection
)
Connector
(
for ROM writer
adapter connection
)
Connector Mark for ROM
installation direction
ROM
LED
To Next Page
Loading...
