June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6 - 27
6
<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-3 "Fig.6-3").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
Fig.6-29
*Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
Fig.6-30
Finisher rear cover
Connector
To Next Page
Loading...
