Toshiba e-STUDIO200L - Page 59

June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 23
2
• List print mode (9S): The procedure varies depending on the code.
• PM support mode (6S):
• Firmware update mode (89): Refer to “6. FIRMWARE UPDATING”.
Fig. 2-1
*1 Turn OFF the power after using the self-diagnosis modes, and leave the equipment to the user.
[9][START]
[POWER]
(Code)
101: Adjustment mode (05)
102: Setting mode (08)
(Code)
103: PM support mode
104: Stored information of pixel counter (toner cartridge reference)
105: Stored information of pixel counter (service technician reference)
106: Error history
[Digital keys]
Key in the first
code to be printed
[Digital keys]
Key in the last
code to be printed
[POWER] OFF/ON
(Exit)
[START]
List starts to
be printed
[START] [START]
[6][START]
[POWER]
(Code)
1: Auto-toner adjustment
2: PM Support Screen
[START]
(Operation started)
[POWER] OFF/ON
(Exit)
Warming up
Control panel
check mode
Test mode
Test print
mode
Adjustment
mode
Setting
mode
List print
mode
PM support
mode
Firmware
update mode
[POWER]
ON
Normal
Ready
[POWER]
OFF
To user
*1
[0][1] [0][3] [0][4] [0][5] [0][8] [9][START] [6][START] [8][9]
State transition diagram of self-diagnosis modes