e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 6
EAE0 Finisher jam Receiving time time-out jam: The printing has been
interrupted because of the communication error
between the equipment and finisher when the
paper is transported from the equipment to the fin-
isher.
P. 5 - 4 6
EAF0 Finisher jam
(Finisher unit)
Stack return jam: It cannot load the paper which
passed through the delivery roller on the intermedi-
ary process tray. [MJ-1022]
P. 5 - 4 4
EB30 Finisher jam Ready time time-out jam: The equipment judges
that the paper transport to the finisher is disabled
because of the communication error between the
equipment and finisher at the start of printing.
P. 5 - 4 6
EB50 Paper transport jam Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper.
P. 5 - 1 2
EB60 Paper remaining on the transport path: The multiple
feeding of preceding paper caused the misfeeding
of upcoming paper (redetection after no jam is
detected at [EB50]).
P. 5 - 1 4
Error code Classification Contents Troubleshooting
To Next Page
Loading...
