1 TROUBLESHOOTING FOR THE HARDWARE
50 Clearing a Staple Jam
Clearing a Staple Jam
When a staple jam has occurred in the stapler of the finisher or saddle stitch unit, clear the jam following the procedure
below.
P.50 “Staple jam in the finisher”
P.56 “Staple jam in the Saddle Stitch unit”
Staple jam in the finisher
Finisher MJ-1101 / MJ-1106
1
Open the front cover of the finisher.
An illustration of MJ-1101 is given in the right-hand figure.
2
Remove the staple cartridge.
3
Lower the guide while holding the knob.
Do not touch the stapling area.
The actual needle point could cause you personal injury.
4
Remove the top staple sheet.
To Next Page
Loading...
Need help?
General
