June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 9
3
[D] Secondary scanning data laser writing start position
This adjustment has to be performed for each paper source. (If there is no paper source, skip this step.)
The following table shows the order of the paper source to be adjusted, code, paper size and accept-
able values.
Perform 08-477 and check the value.
When the value is 0.
When the value is 1.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON. # (Adjustment Mode)
(2) Press [1] ([3] for duplexing) # [FAX]. (A grid pattern with 10 mm squares is printed out.)
(3) Check the grid pattern on the test chart printed out and measure the distance D from the leading
edge of the paper to the 6th line of the grid pattern.
*Normally, the 1st line of the grid pattern is not printed.
*At the duplexing, measure it on the top side of the grid pattern.
(4) Check if the distance D is within 52±0.5 mm.
(5) If not, use the following procedure to change values and measure the distance D again.
(Adjustment Mode) # (Key in the code shown above) # [START]
# (Key in an acceptable value shown above)
# [ENTER] or [INTERRUPT] (Stored in memory)
# “100% A” is displayed
# Press [1] ([3] for duplexing)# [FAX] # (A grid pattern is printed out.)
*The larger the adjustment value is, the longer the distance D becomes (approx. 0.4 mm/step).
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 Lower drawer 441 A3/LD 0 to 40
2 Upper drawer 440 A4/LT 0 to 15
3 PFP or LCF 444/443 A4/LT 0 to 15
4 Bypass feed 442 A4/LT 0 to 15
5 Duplexing 445 A3/LD 0 to 15 Paper fed from the lower drawer
Order for
adjustment
Paper source Code Paper size
Acceptable
value
Remarks
1 Upper drawer 440 A3/LD 0 to 40
2 Lower drawer 441 A4/LT 0 to 15
3 PFP or LCF 444/443 A4/LT 0 to 15
4 Bypass feed 442 A4/LT 0 to 15
5 Duplexing 445 A3/LD 0 to 15 Paper fed from the upper drawer
05/05
To Next Page
Loading...
