Toshiba e-STUDIO230 - Adjustment of the Finisher (MJ-1022)

e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT June 2004 © TOSHIBA TEC
3 - 84
3.12 Adjustment of the Finisher (MJ-1022)
3.12.1 Adjusting the jogging plate width
<Procedure>
(1) Remove the right inner cover and the rear cover.
(4) Measure the jogging width (standard at 317 mm).
(2) Adjust the front jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in ! P.3-84 "Fig.3-109 ".
• Press SW2 twice on the finisher controller
PC board.
- The front jogging plate moves to the
home position.
Fig.3-109
(3) Adjust the rear jogging plate to the home
position.
• Set SW1 on the finisher controller PC
board as shown in ! P.3-84 "Fig.3-110 ".
• Press SW2 twice on the finisher controller
PC board.
- The rear jogging plate moves to the
home position.
Fig.3-110
Fig.3-111
1 2 3 5 6 7 84
ON
1 2 3 4 5 6 7 8
ON
Front jogging plate
home position
Rear jogging plate
home position
Jogging width
317mm