June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ADJUSTMENT
3 - 103
3
(3) Fix the adjustment screws in the position as shown in the figure.
• Dogleg image A
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move upward.
Fig.3-142
• Dogleg image B
Install the adjustment screws as shown in the figure below so that the stay of the fuser unit
can move downward.
Fig.3-143
(4) Check the copied image. If further adjust-
ment is needed, fix the adjustment screws in
the position as shown in the figure so that the
stay can be moved both upward and down-
ward by 1 mm.
Be sure to make the scales on the right and
left match when installing the adjustment
screws.
Fig.3-144
Installation position of the adjustment screws
Adjustment screws
Dogleg image A:
Adjustment screws
Dogleg image B:
Installation position of the adjustment screws
Scale
06/01
To Next Page
Loading...
