June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 67
5
[CB80] Backup RAM data abnormality
MJ-1025
Is the problem solved by turning the power of the equipment OFF and ON?
#
YES End.
NO
1) Replace the finisher controller PC board.
2) Replace the punch controller PC board.
[CC30] Stack processing motor abnormality/Paddle motor abnormality
MJ-1022 (Stack processing motor abnormality)
[Procedure 1]
Is the tension of the drive belt normal?
#
NO Loosen the adjustment screw to adjust its tension.
YES
Does the bushing attached to the returning roller shaft smoothly move up and down?
#
NO Apply grease on the cut-out part of the front side frame where the bush-
ing contacts.
YES
Is the spring of the returning roller detached?
#
YES Attach the spring.
NO
Is the wiring between the finisher controller PC board and stack delivery motor (M2) cor-
rect?
#
NO Correct the wiring.
YES
Is the stack delivery lever home position sensor (S8) working properly?
#
NO Replace the sensor.
YES
1) Replacing the stack processing motor.
2) Replace the finisher controller PC board.
To Next Page
Loading...
