June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 73
5
[CCB0] Rear jogging plate motor abnormality/Alignment motor (rear) abnormality
MJ-1022 (Rear jogging plate motor abnormality)
Is the rear jogging plate home position sensor (S7) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and rear jogging motor (M4) correct?
#
NO Correct the wiring.
YES
Has the rack run over the stopper of the roll?
#
YES Fix it.
NO
1) Replace the rear jogging motor.
2) Replace the finisher controller PC board.
MJ-1025 (Alignment motor (rear) abnormality)
Is the aligning plate home position sensor (rear) (PI5) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and aligning plate home position sen-
sor (rear) correct?
#
NO Correct the wiring.
YES
Is there any mechanical problem with the path of aligning plate?
#
YES Fix the mechanism.
NO
Try replacing the alignment motor (rear) (M5). Is the problem corrected?
#
YES End.
NO
Replace the finisher controller PC board.
To Next Page
Loading...
