June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 TROUBLESHOOTING
5 - 75
5
[CDE0] Paddle motor abnormality
MJ-1025
Is the paddle home position sensor (PI2) working properly?
#
NO Replace the sensor.
YES
Is the Swing guide home position sensor (PI3) working properly?
#
NO Replace the sensor.
YES
Is the wiring between the finisher controller PC board and Paddle motor (M2) correct?
#
NO Correct the wiring.
YES
Try to rotate the paddle motor (M2) clockwise and counterclockwise by hand. Is there
mechanical trapping in the rotation of the paddle or the up/down movement of the swing
guide?
#
YES Fix the mechanism.
NO
1) Replace the paddle motor (M2)
2) Replace the finisher controller PC board.
[CE00] Communication error between finisher and puncher unit
MJ-1025
Is the problem solved by turning the power of the equipment OFF and ON?
#
YES End.
NO
Is the wiring between the finisher controller PC board and the punch controller PC board
correct?
#
NO Correct the wiring.
YES
Measure the voltage between CN14-5 (+) and CN14-3 (-) on the finisher controller PC
board 24 V?
#
NO Replace the finisher controller PC board.
YES
Replace the punch controller PC board.
To Next Page
Loading...
