e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING June 2004 © TOSHIBA TEC
6 - 6
(6) “Update Completed!!” is displayed at the bottom of the LCD screen after the updating is com-
pleted properly.
Fig.6-7
“Update Failed.” is displayed at the bottom of the LCD screen when the updating is not com-
pleted properly. Turn OFF the power, and then check the following items. After confirming and
clearing the problems, restart updating from the beginning.
• Is the download jig connected properly?
• Is the updating data written to the download jig properly?
• Do the download jig and the equipment operate properly?
Fig.6-8
(7) Turn OFF the power, and then remove the download jig.
(8) Perform the “Updating System ROM” continuously.
! P.6-11 "6.1.2 PWA-DWNLD-350-JIG1 (16 MB)" <Updating System ROM>
To Next Page
Loading...
