June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING
6 - 43
6
• Precaution when writing the data
- Set the writing voltage (VID) to 3.3 V.
- When writing the data, set the address from 0 to 3FFFFF. The data may not be written correctly if
it is not set.
- The Flash ROM in which the data will be written, on the download jig is selected by switching the
rotary switch on the adapter. Be sure to switch the rotary switch on the adapter depending on the
data (file) to be written.
Note: Note:
Be sure not to confuse different ROM Versions since the file name is identical although the ROM
version is different.
RotarySwitch File Name Flash ROM
1 firmImage 0.bin ROM1
2 firmImage 1.bin ROM2
3 firmImage 2.bin ROM3
4 N/A ROM4
5 N/A ROM5
6 N/A ROM6
05/11
To Next Page
Loading...
