e-STUDIO200L/202L/230/232/280/282 FIRMWARE UPDATING June 2004 © TOSHIBA TEC
6 - 50
<Updating Finisher ROM>
(1) Install the ROM to the download jig.
Make sure the direction is correct (P.6-32 "Fig.6-35").
(2) Turn OFF the power of the equipment.
(3) Take off the finisher rear cover.
Fig.6-49
*Connect the finisher interface cable with the equipment after removing the finisher rear cover.
(4) Connect the download jig with the jig connector on the finisher control PC board.
Fig.6-50
(5) Change the setting of he DIP switch on the finisher control PC board.
Change all the setting of the DIP switch (1-8) to OFF.
Finisher rear cover
Connector
05/11
To Next Page
Loading...
