June 2004 © TOSHIBA TEC e-STUDIO200L/202L/230/232/280/282 ERROR CODE AND SELF-DIAGNOSTIC MODE
2 - 33
2
[5]
A LCF end fence home position sensor Fence home
position
Other than
home position
B LCF end fence stop position sensor Fence stop
position
Other than
stop position
C LCF standby side empty sensor No paper Paper present
D LCF side cover opening/closing switch Cover closed Cover opened
E LCF motor rotation status (Motor is rotating at output mode
(03))
Abnormal rota-
tion
Normal rota-
tion
F LCF tray-up sensor Tray at upper
limit position
Other than
upper limit
position
G LCF feed sensor No paper Paper present
H LCF feed side empty sensor Paper present No paper
[6]
A - - -
B - - -
C - - -
D - - -
E 1st transport sensor Paper present No paper
F - - -
G Upper drawer empty sensor No paper Paper present
H Upper drawer tray-up sensor Tray at upper
limit position
Other than
upper limit
position
[7]
A - - -
B - - -
C - - -
D - - -
E 2nd transport sensor Paper present No paper
F - - -
G Lower drawer empty sensor No paper Paper present
H Lower drawer tray-up sensor Tray at upper
limit position
Other than
upper limit
position
[8]
A - - -
B Bypass feed paper width sensor-2 Refer to table 1
C Bypass feed paper width sensor-1 Refer to table 1
D Bypass feed paper width sensor-0 Refer to table 1
E - - -
F - - -
G - - -
H - - -
[9]
A - - -
B - - -
C - - -
D Upper drawer detection switch Drawer not
installed
Drawer
present
E Upper drawer paper stock sensor Paper almost
empty
Paper present
F - - -
G - - -
H - - -
Digital
key
Button Items to check
Contents
Highlighted
display
e.g.
Normal dis-
play
e.g.
05/11
To Next Page
Loading...
