e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283 © 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 74
(3) Connect the USB storage device to the USB connector (host) on the SYS board.
Fig. 6-82
• Do not connect multiple USB storage devices together.
• The USB storage device can be connected to either of 2 USB connectors (host).
• In case the printer kit (GM-1020 or 1030), printer/scanner kit (GM-2020 or 2030) and scanner
upgrade kit (GM-3020 or 3030) are used, the update must be performed after all the "don-
gles" are disconnected from the USB connector (host) and only the USB storage device is
connected.
USB storage device
USB connector
(
host
)
To Next Page
Loading...
