© 2004 - 2010 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO200L/202L/203L/230/230L/232/233/280/282/283
FIRMWARE UPDATING
6 - 75
6
(4) Turn ON the power while [4] button and [9] button are pressed simultaneously.
The screen for selecting the items to be updated is displayed after 3 minutes. “*” is displayed
next to the items to be updated. (All items other than "0. OS Update" are selected in the default
settings.)
Fig. 6-83
The display of items on this screen varies depending on the types of data written on the USB
storage device. Each item is displayed only when each data file is written on the USB storage
device in the following conditions.
If the USB storage device is not recognized properly, the following message is displayed. In this
case, turn OFF the power of the equipment and connect the device properly. Then repeat the
procedure from (4).
Fig. 6-84
Item Condition
0. OS Update ROM.bin is written.
1. HDD Update All master data files (1, 2, 3 ... n) are written.
2. UI Data Update ROM.bin is written.
3. System Firmware Update sysfirm.bin and ROM.bin are written.
4. NIC Firmware Update ROM.bin is written.
5. Scanner Firmware Update ROM.bin is written.
6. Machine Firmware Update ROM.bin is written.
To Next Page
Loading...
