6 SETTING ITEMS
100 User Functions Menu Items
INITIAL
SETUP
ECM ON, OFF Switch the ECM (Error Correction Mode)
communication ON or OFF.
ECM is an internationally standardized
communication mode that automatically
corrects errors that occur during fax
transmissions. With this setting option
ON, even when the transmitted data have
been affected by noise during
communication, this mode allows good
communication without image distortion
by automatically resending the part that
have been affected.
Both the sender and the
receiver must have the ECM
function to make ECM
communication available.
When affected by noise during
communication, communication
time is slightly longer than
usual. Even when the ECM
communication is used, an error
may occur depending on the
line status.
The ECM communication is not
available for voice
communication.
RX MODE AUTO, MANUAL Sets the default setting for fax reception
mode.
The following are required for
manual reception.
- Install an external telephone
- Set [REMOTE RX] to [DIAL]
- Receive the fax in Remote RX
when you have an incoming call
REMOTE RX OFF, DIAL Sets the default setting for remote fax
reception mode.
RINGER
VOLUME
Manual Each volume can be set in 8 levels (0:
tone Off).
MONITOR
VOLUME
Manual Monitor tone volume and Reception
completion tone volume (You hear this
tone when reception is completed). Each
volume can be set in 4 levels (0: tone
Off).
COMPLETION
VOLUME
Manual
Menu Functions Settings Descriptions / Reference Pages
To Next Page
Loading...
