2.SENDING A FAX
Basic Procedures 23
2 SENDING A FAX
4
Specify the recipient.
P.35 “Specifying the recipient”
5
Press [START].
The originals are scanned and the fax, reserved.
If memory becomes full during scanning in the memory transmission mode, that
original will not be stored in memory. When that happens, reduce the number of
originals you are sending.
You can check the status of the current transmission. You can also cancel the
transmission (delete the job).
P.43 “Checking and Canceling the Transmissions”
Redial function
In the transmission mode, if the fax cannot be sent due to a busy-line, the fax number is
redialed automatically to send the fax. If you want to change the number of times the
equipment will redial, contact your service technician.
Sending the next original
If an original is placed on the original glass and its scanning is completed, the confirmation
screen for the next original is displayed. To continue scanning the next original, set the original,
select [SCAN NEXT PAGE], and then press [OK]. Once all originals have been scanned, select
[FINISHED] with , and then press [OK].
If you leave the screen unattended for the set auto clear time (45 sec. by manufacturer
default), a copy of the scanned originals is sent.
To cancel the transmission, press [CLEAR/STOP].
P.44 “Canceling transmission when an original is being scanned”
A4
1
100%
01/01 12:01 M:100%
:0123456789_
AUTO EXPOSURE
TEXT/PHOTO
To Next Page
Loading...
