1 TROUBLESHOOTING FOR THE HARDWARE
68 Cleaning the Hole Punch Dust Bin
Cleaning the Hole Punch Dust Bin
When the hole punch dust bin becomes full, dispose of the paper punchings following the procedure below.
Finisher / Saddle Stitch Finisher Hole Punch Unit
3
Dispose of the paper punchings.
4
Push back in the hole punch dust bin.
5
Close the Hole Punch Unit cover.
Inner Finisher Hole Punch Unit
1
Open the Hole Punch Unit cover.
2
Pull out the hole punch dust bin.
1
Lift up the control panel and then open the front cover
of the finisher.
2
While holding the green lever, move the finisher to the
left until it stops.
2
1
2
1
To Next Page
Loading...
Need help?
General
