e-STUDIO200L/202L/203L/230/232/233/280/282/283 © 2004 - 2008 TOSHIBA TEC CORPORATION All rights reserved
GENERAL OPERATION
4 - 10
• Exit sensor detects jamming of the tailing edge of paper.
Registration clutch OFF
Fig. 4-2
Less than 1.759 sec.
Exit sensor OFF
If the exit sensor is not turned OFF after 1.759
sec,
Paper jam (E020) The copying operation
is stopped.
• Immediately after the power ON
Any of all sensors on paper transport path detects paper (ON)
Paper jam (E030)
• Front cover is opened during copying
Paper jam (E410)
• Registration sensor detects jamming of the leading edge of paper:
Registration sensor is not turned ON in a fixed period of time after the leading edge of paper
passed the 1st transport roller.
Paper jam (E200, E210, E270, E280, E300, E330 and E3C0)
• During paper feeding from ADU:
1st transport sensor is not turned ON in a fixed period of time after the ADU clutch is turned ON.
Paper jam (E110)
• During paper transporting from ADU:
ADU entrance/exit sensors do not detect the paper at the fixed timing
Paper jam (E510 or E520)
Registration clutch
Exit sensor
Timer
0
Paper jam (E020)
ON
OFF
1.759sec.
To Next Page
Loading...
