Overview of Machine
-18-
Available Options
The following options are available for your
machine:
z Second tray unit (tray 2)
Reference
z For details on how to install the options, refer to "Installing
Options" P. 26.
Installation Requirements
Installation Environment
Your machine must be installed in the following
environment:
Note
z Be careful of condensation. It may cause a malfunction.
z If installing your machine where the humidity of the
surrounding air is less than 30% RH, use a humidifier or
antistatic mat.
Temperature: 10°C~32°C
Humidity: 20%~80% RH(relative
humidity)
Maximum wet
bulb temperature: 25°C
z Do not install near high temperature or the fire.
z Please do not install in a place from which
chemical reactions take place (laboratory etc.).
z Do not install near inflammable solutions, such as
alcohol and thinner.
z Do not install in places easily accessible to small
child.
z Do not install in an unstable place (the shaky
stand, leaning place, etc.).
z Do not install in a place exposed to high humidity,
dust or direct sunlight.
z Do not install in an environment exposed to briny
air or corrosive gas.
z Do not install in a place with much vibration.
z Do not install in a place where the ventilation hole
of the machine is blocked.
z Do not place directly on a rug or carpet with long
strands.
z Do not install in a closed room with poor
ventilation and circulation.
z If you use the machine in a small room for a long
time, please make sure that you ventilate the
room.
z Install away from strong magnetic fields and
sources of noise.
z Install away from monitors or TVs.
z When moving the machine, hold it on both sides,
and move it by slightly letting the back of it fall.
WARNING
CAUTION
To Next Page
Loading...
