GENERAL PRECAUTIONS REGARDING THE INSTALLATION
AND SERVICE FOR e-STUDIO350/352/353/450/452/453
The installation and service should be done by a qualified service
technician.
1) Transportation / Installation
- When transporting/installing the equipment, employ two persons and be sure to use the positions
as indicated below.
The equipment is quite heavy and weighs approximately 83kg (182.98 lb.): e-STUDIO350/450 /
86kg (189.59 lb.): e-STUDIO352/353/452/453 therefore pay fullattention when handling it.
- Be sure not to hold the movable parts or units (e.g. the control panel, ADU or RADF) when trans-
porting the equipment.
- Be sure to use a dedicated outlet with AC 110V/13.2A, 115V or 127V / 12A, 220-240V or 240V /
8A for its power source.
- The equipment must be grounded for safety.
Never ground it to a gas pipe or a water pipe.
- Select a suitable place for installation.
Avoid excessive heat, high humidity, dust, vibration and direct sunlight.
- Also provide proper ventilation as the equipment emits a slight amount of ozone.
- To insure adequate working space for the copying operation, keep a minimum clearance of 80
cm (32”) on the left, 80 cm (32”) on the right and 10 cm (4”) in the rear.
- The socket-outlet shall be installed near the equipment and shall be easily accessible.
- Be sure to fix and plug in the power cable securely after the installation so that no one trips over
it.
07/11
To Next Page
Loading...
