Toshiba e-STUDIO350 - 6.2 Firmware Updating with Download Jig (e-STUDIO352;353;452;453)

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
FIRMWARE UPDATING
6 - 34
6.2 Firmware Updating with Download Jig
(e-STUDIO352/353/452/453)
In this equipment, it is feasible to update the firmware automatically by connecting the download jig
using the dedicated connector and turning ON the equipment.
The download jig consists of the ROM, in which the program is written, and the jig board.
And two types of the download jigs are available for each type of the firmware.
For updating the firmware, in addition to the current ways such as updating each firmware individually,
the batch update of the firmware of the equipment is available (except the hard disk and the option).
Refer to the following for the details to update with each download jig.
 P. 6-36 "6.2.1 PWA-DWNLD-350-JIG2 (48 MB)"
 P. 6-50 "6.2.2 Writing the data to the download jig (PWA-DWNLD-350-JIG)"
Firmware Stored
Download jig
Batch update Individual update
System ROM System control PC board
(SYS board)
* The system firmware is
stored into the hard disk
from the FROM basic
section software version
“V1.00/4.22”.
PWA-DWNLD-350-
JIG2 (48 MB)
-
Engine ROM Logic PC board
(LGC board)
K-PWA-DLM-320
Scanner ROM Scanning section control PC
board
(SLG board)
K-PWA-DLM-320
RADF ROM RADF control PC board
(MR-3018)
- K-PWA-DLM-320
Finisher ROM
(Finisher firmware)
Finisher control PC board
(MJ-1023/MJ-1024/MJ-1101)
- K-PWA-DLM-320
Finisher ROM
(Saddle stitcher firmware)
Finisher control PC board
(MJ-1024)
- K-PWA-DLM-320
FAX ROM FAX board (GD-1200) - K-PWA-DLM-320
07/11