Toshiba e-STUDIO350 - Adjusting the Angle of the Jogging Plate

To Next Page

To Previous Page

ADJUSTMENT

3 - 85

3.12.2 Adjusting the angle of the jogging plate

(1) Without removing the processing tray unit, loosen the 2 mounting screws of the rear jogging

plate.

Fig. 3-119

(2) Place several sheets of A4/LT paper on the processing tray, and adjust the rear jogging plate. (At

this time, adjust the gap between the paper and the front end of the rear jogging plate so that it is

0 mm to 0.5 mm.)

(3) With reference to the rear jogging plate adjusted in step (2), adjust the front jogging plate in the

same manner.

Screw

Rear jogging plate

Paper

Butted

0 mm to 0.5 mm

Screw

Rear jogging

plate

Other manuals for Toshiba e-STUDIO350