Toshiba e-STUDIO350 - Page 358

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 70
(3) Loosen the hinge screws at the front side.
Fig. 3-89
(4) Position the pins with the holes on the RADF
by moving it so that the pins fit into the holes
when the RADF is closed.
Fig. 3-90
(5) Tighten the left-hand hinge screw at the rear
side.
Fig. 3-91
05/11