Toshiba e-STUDIO350 - Page 568

e-STUDIO350/352/353/450/452/453 © 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved
TROUBLESHOOTING
5 - 132
(3) Print out the “FUNCTION” list.
• Press the [USER FUNCTIONS] button.
• Press the [ADMIN] button, enter the password, and then press the [ENTER] button.
• Press the [LIST/REPORT] button and then the [LIST] button.
• Press the [FUNCTION] button. The list is outputted.
(4) Replace the HDD.
(5) Update of HDD program data and UI data.
• Create partitions. (In case of using the download jig, this is not necessary.)
While pressing [3] and [CLEAR] button, turn the power ON. When “Firmware Version Up
Mode” appears on the LCD, key in [3] and press the [START] button.
• Update with the USB storage. See “6. FIRMWARE UPDATING” for details.
• Format the HDD. (Setting Mode (08-690: 2))
* When the FAX unit (GD-1150/1200) is installed. Start up with the FAX Clearing Mode (1*).
Perform the 1*-100 (FAX Set Up), 1*-102 (Clearing the image data) of the FAX Clearing
Mode.
• Perform the gamma automatic adjustment of the printer. See “3.6.1 Automatic gamma adjust-
ment” for details.
(6) Ask users to reset the user’s setting items and to restore the data/information. See the following
for the reset and the restore.
• Printer driver
- Upload them in the “Administrator” menu of TopAccess.
• F-code information, Template registering information, Address book
- Restore them in the “Administrator” menu of TopAccess
• Department management data
- Import them in the “Administrator” menu of TopAccess.
• Image data in the Electronic Filing
- Upload them in the “e-Filing” of TopAccess.
• When the SSL is enabled, perform the setting of the following items again with "Create self-
certificate" of TopAccess. (e-STUDIO352/353/452/453)
Country Name
State or Province Name
Locality Name
Organization Name
Organizational Unit Name
Common Name
Email Address
• When wireless LAN is used, perform the setting again on the LCD panel. (only when security
with a certificate is used)
Also, upload the following certificate file with "Install Certificate for Wireless LAN" of TopAc-
cess. (e-STUDIO352/353/452/453)
CA certificate
User certificate
(7) Referring to the “FUNCTION LIST FOR MAINTENANCE” list which was printed beforehand, per-
form the re-setting.
• Print out the “FUNCTION LIST FOR MAINTENANCE” list after the formatting. (Refer to the
procedure of (2).)
• While pressing [1] and [3] simultaneously, turn the power ON. (Function Mode)
• Compare the lists which were printed before and after the formatting to check the setting
items having the different setting values. Set the value which was set before the formatting.
• Turn the power OFF.
07/11