© 2003 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO350/352/353/450/452/453
FIRMWARE UPDATING
6 - 37
6
(4) Connect the download jig with the jig connector (CN100) on the SYS board.
Fig. 6-31
(5) Turn ON the power while [8] button and [9] button are pressed simultaneously.
The screen for selecting the items to be updated is displayed. “*” is displayed next to the items to
be updated. (All items are selected in the default settings.)
When the FROM basic section software version to be updated is "V1.00 / 1.12" or earlier:
Fig. 6-32
When the FROM basic section software version to be updated is "V1.00 / 4.22" or later:
Fig. 6-33
Connector
06/10
To Next Page
Loading...
